Appendix 3 Error List

Note: for the errors listed below, you may click “Clear” to check related parts.

Error Number

Error

Solutions

EC08

Pll bar

Press  “” button ➜


EC09

Back to the beginning, thenpull backward bar again

The operating error.


EC11

No such design in memory

Select other designs.


EC12

Main shaft not stop inposition1. Turn the handwheel by hand, until to on screen.2.Press button.


EC13

Frame over border

1. select the frame consistent  with actual size

2. select “no”. turn off this function.


EC14

Part of memory lost

Replace battery on mainboard


EC16

Sep motor

1.check Mechanical transmission2.check X Y motor3.check X Y driver


EC17

Color changing overtime

1.check the color motor. Check motor driver board PC501/PC502.2.check the sensor.


EC18

Color changing half rotationabnormalAdjust by turning the handwheel by hand.


EC19

Need position abnormal1.Adjust by turning the handwheelby hand.2. check the sensor. 


EC20

Main motor overtime

1.turning the handwheel byhand Check whether the load is too heavy;2.turning the handwheel by hand At least one circle ,there is a change , observe the icon on screen. ifno change,clear or replace E923 board.3.Test “machine Test” ➜ “Test Encoder Parameters”OPL 60 ± 10APL 2000 ± 3BPL 2000 ± 3If not right,check motror encoder plug connect to driver.4. Replace driver.


.

EC21

Color changing out.

“Needles” parameter setting mustequal to the machine’ s actual needles. 9 or 12 or 15.


EC26

Trimming not in position.

Check whether the detection sensor is damaged.

EC41

Files not exist in disk.

1.Try again.2.Restart machine and then try again.3.execute “clear All Designs”.Input designs again.


EC42

Disk dir full.

Delete useless Designs. Free Memory.


EC43

Disk space full.

Delete useless Designs. Free Memory.


EC44

File distribution list error.execute “clear All Designs”.


EC45

Dir error.

execute “clear All Designs”.


EC208

The same method as EC20.

Categories: Uncategorized